×
Suggest this Article to:
TOP INDEXERS
Public Paper
-
Approximate Designing of Blade of Axial Pump by Steel and Composite Material
ISSN: en
Publisher: author
Approximate Designing of Blade of Axial Pump by Steel and Composite Material
View Paper PDF
Abstract
Profile of the blade of a pump is usually airfoil. Airfoils are hard to manufacture and expensive, but they have high efficiency. Because of wide application of pumps in industry, in this paper, a simple method for designing airfoil of an axial pump has been presented. In this method, the blade of the pump has been simulated with a cantilever beam with rectangular cross section and thickness of it for steel material has been calculated by means of modified Goodman criterion. Then, the rectangular cross section is approximated with a proper airfoil of NACA series. This process is repeated for composite material by similar methods. The results shows lightweight of the composite blade into steel one.    Index Terms— Axial pump, Turbomachine, Design, Airfoil, NACA, CompositeÂ
SUBMIT CONCEPT ASK QUESTION
International Category Code (ICC):
ICC-0202
Mehdi Shahabi, Yaghoub Tadi
International Article Address (IAA):
IAA.ZONE/en8328en
Paper Profile:
Private
Visitors: 0
Paper Evaluation: Pending
ASI-Factor: 0
Paper Improving: Pending
Paper Flaws: 0
References
No citation was entered yet.
